No vlan – Allied Telesis AT-8100 Series User Manual
Page 929
AT-8100 Switch Command Line User’s Guide
929
NO VLAN
Syntax
no vlan
vid
Parameters
vid
Specifies the VID of the VLAN you want to delete.
Mode
VLAN Configuration mode
Description
Use this command to delete port-based or tagged VLANs from the switch.
Here are the guidelines to this command:
You cannot delete the Default_VLAN.
The switch automatically returns the untagged ports of a deleted
VLAN to the Default_VLAN, as untagged ports.
Static addresses assigned to the ports of a deleted VLAN become
obsolete and should be deleted from the MAC address table. For
instructions, refer to “NO MAC ADDRESS-TABLE STATIC” on
page 392.
To delete a VLAN that has authenticator or supplicant ports for
802.1x port-based network access control, you must first change
the ports to the 802.1x none role. For instructions, refer to “NO
DOT1X PORT-CONTROL” on page 1129.
Confirmation Command
Example
This example deletes the VLAN with the VID 5:
awplus> enable
awplus# configure terminal
awplus(config)# vlan database
awplus(config-vlan)# no vlan 5