Enabling snmpv1 and snmpv2c, Enabling snmpv1 and snmpv2c 6 – Allied Telesis AT-8100 Series User Manual

Page 1146

Text mode
Original mode

Chapter 73: SNMPv1 and SNMPv2c

1146

Enabling SNMPv1 and SNMPv2c

To enable SNMP on the switch, use the SNMP-SERVER command, found
in the Global Configuration mode. The command has no parameters. The
switch begins to send trap and inform messages to the receivers and
permits remote management from SNMP workstations as soon as you
enter the command. This assumes, of course, you have already created
the community strings and added the IP addresses of trap and inform
receivers. Here is the command:

awplus> enable
awplus# configure terminal
awplus(config)# snmp-server