Allied Telesis AT-8100 Series - Manual (Page 556)

Chapter 35: File System Commands
556
MOVE
Syntax
move filename1 .cfg filename2 .cfg
Parameters
filename1.cfg
Specifies the name of the boot configuration file to be renamed.
filename2.cfg
Specifies the new name for the file. The filename can be from 1 to
16 alphanumeric characters, not including the filename extension,
which must be “.cfg”. The filename cannot contain spaces or
special characters.
Mode
Privileged Exec mode
Description
Use this command to rename boot configuration files in the switch’s file
system.
Note
If you rename the active boot configuration file, the switch recreates
it the next time you issue the WRITE command or the COPY
RUNNING-CONFIG STARTUP-CONFIG command.
Note
If you rename the active boot configuration file and reset the switch
without specifying a new active boot configuration file or issuing the
WRITE command or the COPY RUNNING-CONFIG STARTUP-
CONFIG command, the switch returns to its default settings.
Example
This example renames the file “sw12.cfg” to “swrm102.cfg:”
awplus# move sw12.cfg swrm102.cfg