Allied Telesis AT-8100 Series - Manual (Page 390)

Chapter 20: MAC Address Table Commands
390
MAC ADDRESS-TABLE STATIC
Syntax
mac address-table static macaddress forward|discard
interface port [vlan vlan-name | vid ]
Parameters
macaddress
Specifies the static unicast address you want to add to the switch’s
MAC address table. The address must be specified in either one of
the following formats: xx:xx:xx:xx:xx:xx or xxxx.xxxx.xxxx
forward
Forwards packets containing the designated source MAC address.
discard
Discards packets containing the designated source MAC address.
port
Specifies the port(s) where the MAC address is to be assigned. A
unicast MAC address can be added to only one port.
vlan-name
Specifies the name of the VLAN where the node designated by the
MAC address is a member.
vid
Specifies the ID number of the VLAN where the node designated
by the MAC address is a member. This parameter is optional.
Mode
Global Configuration mode
Description
Use this command to add static unicast MAC addresses to the switch’s
MAC address table. A static MAC address is never timed out from the
MAC address table, even when the end node is inactive. You can add just
one static MAC address at a time with this command.
The FORWARD and DISCARD parameters are used to specify whether
the switch is to forward or discard packets containing the specified source
MAC address.