Allied Telesis AT-8100 Series - Manual (Page 1222)

Chapter 77: sFlow Agent Commands
1222
SFLOW POLLING-INTERVAL
Syntax
sflow polling-interval polling-interval
Parameters
polling-interval
Specifies the maximum amount of time permitted between
successive pollings of the packet counters of a port by the agent.
The range is 0 to 16777215 seconds.
Mode
Port Interface mode
Description
Use this command to set the polling intervals for the ports. This controls
the maximum amount of time permitted between successive pollings of
the packet counters on the ports by the sFlow agent. The ports can have
different polling intervals.
To remove sFlow monitoring from a port, enter the NO form of this
command, NO SFLOW POLLING-INTERVAL.
You must disable the sFlow agent to set or change the polling interval of a
port. For instructions, refer to “NO SFLOW ENABLE” on page 1219.
Confirmation Commands
“SHOW SFLOW” on page 1226
Examples
This example sets the polling interval for ports 13 to 15 to 3600 seconds
(one hour):
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.13-port1.0.15
awplus(config-if)# sflow polling-interval 3600