Allied Telesis AT-8100 Series - Manual (Page 1288)

Chapter 79: LLDP and LLDP-MED Commands
1288
LOCATION COORD-LOCATION
Syntax
location coordinate-location identifier id_number
Parameters
id_number
Specifies an ID number for an LLDP-MED coordinate location
entry. The range is 1 to 256. (This range is independent from the
ID number ranges for civic and ELIN location entries.) You can
specify only one ID number.
Mode
Global Configuration mode
Description
Use this command to create or modify LLDP-MED coordinate location
entries on the switch. This command moves you to the Coordinate
Location mode which contains the parameters you use to define the
entries. The parameters are listed in Table 131.
Table 131. LLDP-MED Coordinate Location Entry Parameters
Parameter Value
latitude Latitude value in decimal degrees
The range is -90.0º to 90.0º. The
parameter accepts up to eight
digits to the right of the decimal
point.
lat-resolution Latitude resolution as the number
of valid bits. The range is 0 to 34
bits.
longitude Longitude value in decimal
degrees. The range is -180.0º to
180.0º. The parameter accepts up
to eight digits to the right of the
decimal point.
long-resolution Longitude resolution as the
number of valid bits. The range is
0 to 34 bits.