Allied Telesis AT-8100 Series - Manual (Page 710)

Chapter 46: Event Log Commands
710
SHOW LOG PERMANENT TAIL
Syntax
show log permanent tail [ number ]
Parameters
number
Specifies the number of log entries to display. The range is 10 to
250 messages. The default is 10 messages.
Mode
Privileged Exec mode
Description
Use this command to display the most recent event messages in the
permanent event log. The NUMBER parameter is used to specify the
number of messages to display. The messages are displayed from oldest
to newest. For an example and description of the log, refer to Figure 136
on page 709 and Table 80 on page 704.
Examples
This example displays the most recent 10 log messages in the permanent
log:
awplus# show log permanent tail
This example displays the most recent 30 log messages in the permanent
log:
awplus# show log permanent tail 30