Ipv6 route – Allied Telesis AT-8100 Series User Manual
Page 324
Chapter 14: IPv4 and IPv6 Management Address Commands
324
IPV6 ROUTE
Syntax
ipv6 route ::/0
ipaddress
Parameters
ipaddress
Specifies an IPv6 address of a default gateway. The address is
entered in this format:
nnnn:nnnn:nnnn:nnnn:nnnn:nnnn:nnnn:nnnn
Where N is a hexadecimal digit from 0 to F. The eight groups of
digits have to be separated by colons. Groups where all four digits
are ‘0’ can be omitted. Leading ‘0’s in groups can also be omitted.
Mode
Global Configuration mode
Description
Use this command to assign the switch an IPv6 default gateway address.
A default gateway is an address of an interface on a router or other Layer
3 device. It defines the first hop to reaching the remote subnets or
networks where the network devices are located. You must assign the
switch a default gateway address if both of the following are true:
You assigned the switch an IPv6 management address.
The remote management devices (such as Telnet workstations
and TFTP servers) are not members of the same subnet as the
IPv6 management address.
Review the following guidelines before assigning a default gateway
address:
The switch can have just one IPv6 default gateway.
The switch must already have an IPv6 management address.
The IPv6 management address and the default gateway address
must be members of the same subnet.
Confirmation Command