Allied Telesis AT-8100 Series - Manual (Page 1690)

Chapter 100: Quality of Service (QoS)
1690
Displaying QoS Settings
There are eight commands that display the QoS settings. See Table 232
for a description of these commands. The following sections provide
additional descriptions of the commands, as well as examples of the
displays:
 “Displaying QoS Status” on page 1691
 “Displaying a Class Map” on page 1691
 “Displaying a Policy Map” on page 1692
 “Displaying Aggregate Policers” on page 1692
 “Displaying QoS Scheduling Information” on page 1692
 “Displaying CoS to Queue Mappings” on page 1693
 “Displaying DSCP to Queue Mappings” on page 1694
 “Displaying DSCP to Policed-DSCP Values” on page 1695
Note
To display information about QoS Storm Control, see “Displaying
Port Storm Status” on page 1797.
Table 232. QoS Display Commands
To Do This Task Use This Command
Displays the status of the QoS feature. show mls qos
Displays the contents of a class map
when a class map name is specified.
Without a class map name, it displays
all class maps configured on the
switch. show class-map class-map-name
Displays the settings of the given policy
map. Without a policy-map name,
displays a list of all the QoS policy
maps configured on the switch. show policy-map policy-map-name
Displays all configured aggregate
policers on the switch. show mls qos aggregate-policer name
Displays the scheduling methods of the
specified port and, for weighted round
robin scheduling, the assignments of
weights to egress queues. show mls qos interface port