Enabling lldp and lldp-med on the switch, Enabling lldp and lldp-med on the switch 5 – Allied Telesis AT-8100 Series User Manual

Page 1235

Text mode
Original mode

AT-8100 Switch Command Line User’s Guide

1235

Enabling LLDP and LLDP-MED on the Switch

To enable LLDP and LLDP-MED on the switch, use the LLDP RUN
command in the Global Configuration mode. The switch begins to transmit
advertisements from those ports that are configured to send TLVs, and
begins to populate its neighbor information table as advertisements from
the neighbors arrive on the ports. The command does not support any
parameters. Here is the command:

awplus> enable
awplus# configure terminal
awplus(config)# lldp run

To deactivate LLDP and LLDP-MED, refer to “Disabling LLDP and LLDP-
MED on the Switch” on page 1254.