Allied Telesis AT-8100 Series - Manual (Page 1710)

Chapter 101: QoS Commands
1710
DESCRIPTION (Policy Map)
Syntax
description line
Parameters
line
Specifies an 80-character description of the QoS policy map.
Mode
Policy Map mode
Description
Use this command to add a description to the specified policy map.
Use the no version of this command, NO DESCRIPTION, to remove a
description from the specified policy map.
Confirmation Command
“SHOW RUNNING-CONFIG” on page 170
Examples
To add a description of “VOIP traffic” to a policy map called “pmap20,” do
the following:
awplus> enable
awplus# configure terminal
awplus(config)# policy-map pmap20
awplus(config-pmap)# description VOIP traffic
To add a description of “Video traffic” to a policy map called “pmap1,” do
the following:
awplus> enable
awplus# configure terminal
awplus(config)# policy-map pmap1
awplus(config-pmap)# description Video traffic