Allied Telesis AT-8100 Series - Manual (Page 694)

Chapter 46: Event Log Commands
694
LOG BUFFERED
Syntax
log buffered [level level ] [program program ] [msgtext
msgtext ]]
Parameters
level
Specifies the minimum severity level of the event messages to be
stored in the buffered event log. The log stores the messages of
the specified level and all higher levels. For example, if you specify
level 4, the log stores the messages from levels 0 and 4. The
severity levels are listed in Table 79. At the default level 6, the log
stores messages that have a severity level of 0, 4, or 6.
program
Specifies the event messages of a particular management
software module. The modules are listed in Table 81 on page 705.
To specify more than one module, separate the modules with
commas.
msgtext
Specifies a text string in the event messages. This string is case
sensitive. The text may not contain spaces or special characters
and must not be enclosed in quotation marks. To use this
parameter, you have to include the LEVEL and PROGRAM
parameters in the command and it has to be the last parameter in
the command.
Mode
Global Configuration mode
Description
Use this command to specify the types of event messages the buffered log
should store. You can specify the messages by severity level,
management software module, a text string, or a combination of the
parameters.
The available severity levels are listed in Table 79.
Table 79. Event Message Severity Levels
Severity Description
0 Emergency message