Allied Telesis AT-8100 Series - Manual (Page 1310)

Chapter 79: LLDP and LLDP-MED Commands
1310
Network Policy The network policy information configured
on the port for connected media endpoint
devices. The switch supports Application
Type 1: Voice, including the following
network policy for connected voice
devices to use for voice data:
 Voice VLAN ID
 Voice VLAN Class of Service (CoS)
priority
Voice VLAN Diffserv Code Point (DSCP)
Application Type The switch supports Application Type 1:
Voice.
Frame Format The frame format specifies the port type
connected to a VLAN as tagged or
untagged.
VLAN ID The Virtual Local Area Network ID (VID).
Layer 2 Priority Layer 2 user priority is in the range of 0 to
7.
DSCP Value Indicates a DSCP priority level. The range
is 0 to 63. A level of 0 is the lowest
priority, and a level of 63 is the highest
priority.
Location Identifier Specifies an ID number for an LLDP-MED
civic location entry on the switch. The
range is 1 to 256.
Extended Power via MDI
(PoE) The extended power via MDI capabilities
of the port.
Inventory Information
Hardware Revision The hardware revision number of the
chassis.
Firmware Revision The revision number of the bootloader on
the chassis.
Software Revision The revision number of the management
software on the chassis.
Serial Number The serial number of the device.
Table 133. SHOW LLDP NEIGHBORS DETAIL Command (Continued)
Parameter Description