Allied Telesis AT-8100 Series - Manual (Page 621)

AT-8100 Switch Command Line User’s Guide
621
The information the command displays is explained in Table 63.
Table 63. SHOW IP IGMP SNOOPING Command
Parameter Description
IGMP Snooping Configuration
IGMP Snooping Status The status of IGMP snooping on the
switch. To enable or disable the feature,
refer to “IP IGMP SNOOPING” on
page 613 and “NO IP IGMP SNOOPING”
on page 618, respectively.
Host Topology The IGMP host node topology on the
switch. The possible topologies are:
singlehost— This is the single-host per
port topology. This topology is appropriate
when there is only one host node per port
on the switch. This is the default setting.
multihost— This is the multiple-host per
port topology. This topology is appropriate
when there is more than one host node
per port on the switch.
To set this parameter, refer to “IP IGMP
STATUS” on page 617.
Host/Router Timeout
Interval The amount of time the switch uses to
time out inactive host nodes and multicast
routers. To set this parameter, refer to “IP
IGMP QUERIER-TIMEOUT” on
page 612.
Maximum IGMP Multicast
Groups The maximum number of multicast groups
the switch supports. To set this parameter,
refer to “IP IGMP LIMIT” on page 611.
Router Port(s) The ports connected to multicast routers.
The switch can learn the router ports
automatically or you can assign them
manually. To assign the ports manually,
refer to “IP IGMP SNOOPING
MROUTER” on page 616.
Router List
VLAN ID The ID numbers of the VLANs of the
router ports.