Allied Telesis AT-8100 Series - Manual (Page 1291)

AT-8100 Switch Command Line User’s Guide
1291
LOCATION ELIN-LOCATION
Syntax
location elin-location elin_id identifier id_number
Parameters
elin_id
Specifies the ELIN (Emergency Location Identification Number) of
10 to 25 digits.
id_number
Specifies an ID number for an LLDP-MED coordinate location entry
on the switch. The range is 1 to 256. (This range is separate from
the ranges for civic and coordinate entries.) You can specify only
one ID number.
Mode
Global Configuration mode
Description
Use this command to create or modify LLDP-MED ELIN location entries on
the switch. To create a new ELIN TLV, specify an unused ID number. To
modify an existing ELIN TLV, enter its ID number.
To assign ELIN location entries to ports on the switch, use “LLDP
LOCATION” on page 1267.
To remove an ELIN location entry, use “NO LOCATION” on page 1299.
Confirmation Command
“SHOW LOCATION” on page 1318
Example
This example creates a new location entry for ELIN 1234567890, with the
ID number 15:
awplus> enable
awplus# configure terminal
awplus(config)# location elin-location 1234567890 identifier
15