Allied Telesis AT-8100 Series - Manual (Page 1744)

Chapter 101: QoS Commands
1744
NO AUTO-QOS VOICE | TRUST DSCP
Syntax
no auto-qos [voice |trust dscp]
Parameters
voice
Specifies a VLAN ID for voice VLAN support. Enter a value
between 1 and 4094.
trust dscp
Specifies DSCP traffic is trusted.
Mode
Interface Configuration mode
Description
Use this command to do one of the following:
 Remove a voice VLAN ID.
 Remove DSCP as trusted ingress traffic.
 Remove a voice VLAN ID and remove DSCP as trusted ingress
traffic.
Confirmation Command
“SHOW RUNNING-CONFIG” on page 170
Examples
In the following example, VLAN 100 is removed as a voice VLAN, and
trust CoS is removed from port 1.0.1:
awplus> enable
awplus# configure terminal
awplus(config-if)# interface port1.0.1
awplus(config)# no auto-qos voice 100
In the following example, VLAN 50 is removed as a voice VLAN from port
1.0.1:
awplus> enable
awplus# configure terminal
awplus(config-if)# interface port1.0.1
awplus(config-if)# no auto-qos voice 50