Stack – Allied Telesis AT-8100 Series User Manual
Page 411
AT-8100 Switch Command Line User’s Guide
411
STACK
Syntax
stack
old_id
renumber
new_id
Parameters
old_id
Specifies the current ID number of the switch. This number is
displayed on the Stack ID LED and with “SHOW STACK” on
page 410. You can enter only one ID number.
new_id
Specifies the switch’s new stack ID number. The range is 0 to 8.
You can enter only one ID number.
Mode
Global Configuration mode
Description
Use this command to set the stack ID number of the switch. The switch
can have only one ID number. The number should be set before the switch
is connected to the stack. The range is 0 to 8. Assign stand-alone switches
the stack ID number of 0.
This command displays a confirmation prompt. Type Y to renumber the
switch or N to cancel the procedure.
Caution
This command causes the switch to reset. The switch does not
forward network traffic while it initializes its management software.
Some network traffic may be lost.
Confirmation Command
Examples
This example assigns the stack ID number 1 to a switch that currently has
the ID number 0:
awplus> enable
awplus# configure terminal
awplus(config)# stack 0 renumber 1