Allied Telesis AT-8100 Series - Manual (Page 410)

Chapter 22: Stacking Commands
410
SHOW STACK
Syntax
show stack
Parameters
None
Mode
Privileged Exec mode
Description
Use this command to display the stack ID numbers, MAC addresses, and
other information of the switches in a stack. The information the command
displays depends on whether the switch is acting as a stand-alone unit or
as part of a stack. For further information, refer to “Displaying the Switches
of a Stack” on page 406.
Figure 95 is an example of the information the command displays.
Figure 95. SHOW STACK Command
Example
The following example displays the stack ID numbers and MAC addresses
of the switches in a stack:
awplus> enable
awplus# show stack
Stacking summary Information:
ID
MACADDRESS SwVer Model Status Role
1 eec5.611d.6a54 2.2.5.0 AT-8100S/24C Ready Master
2 eccd.6d4b.2492 2.2.5.0 AT-8100S/24F-LC Ready Member
3 0015.7700.010e 2.2.5.0 AT-8100S/16F8-SC Ready Member
4 00a0.d299.aabb 2.2.5.0 AT-8100S/24F-LC Ready Member
5 eccd.6d1e.56c6 2.2.5.0 AT-8100S/48 Ready Member
6 0000.0000.0101 2.2.5.0 AT-8100S/16F8-SC Ready Member
7 eccd.6d1e.17cc 2.2.5.0 AT-8100S/24POE Ready Member
Operational status: Ring topology is broken
Master Module ID: 1
Stack MAC Address: eec5.611d.6a54
Local Module ID: 1
Local MAC Address: eec5.611d.6a54