Allied Telesis AT-8100 Series - Manual (Page 1106)

Chapter 72: 802.1x Port-based Network Access Control Commands
1106
AUTH-MAC ENABLE
Syntax
auth-mac enable
Parameters
None
Mode
Port Interface mode
Description
Use this command to activate MAC address-based authentication on
authenticator ports. An authenticator port that uses this type of
authentication extracts the source MAC address from the initial frames
from a supplicant and automatically sends it as the supplicant’s username
and password to the authentication server. This authentication method
does not require 802.1x client software on supplicant nodes.
Confirmation Command
“SHOW AUTH-MAC INTERFACE” on page 1131
“SHOW DOT1X INTERFACE” on page 1136
Example
This example activates MAC address-based authentication on ports
1.0.15 and 1.0.18:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.15,port1.0.18
awplus(config-if)# auth-mac enable