Allied Telesis AT-8100 Series - Manual (Page 406)

Chapter 21: Hardware Stacking
406
Displaying the Switches of a Stack
The SHOW STACK command in the Privileged Exec mode displays the
stack ID numbers and MAC addresses of the switches of a stack:
awplus> enable
awplus# show stack
The information the command displays depends on whether the switch is
a stand-alone unit or part of a stack. If the switch is assigned the stack ID
number 0, the ID number for a stand-alone unit, the command displays
this prompt:
% Stacking is disabled on this switch.
If the switch has a stack ID number of 1 to 8, but is not connected to a
stack, the command displays the stack ID number and MAC address of
the switch. Here is an example of the information.
Figure 93. SHOW STACK Command for a Stand-alone Switch with a
Stack ID of 1 to 8
It the switch is part of an active stack, the command lists information about
the switches. The example in Figure 94 on page 407 shows a stack of four
switches.
Stacking summary Information:
ID MACADDRESS SwVer Model Status Role
Operational status Standalone unit
Local Module ID: 1
Local MAC Address: 00:00:54:55:56:42