Allied Telesis AT-8100 Series - Manual (Page 1616)

Chapter 99: ACL Commands
1616
ipaddress/mask: Matches packets that have a destination IPv6
address of a subnet or an end node in the X:X::X:X/mask
format. The mask is a decimal number that represents the
number of bits in the address, from left to right, that constitute
the network portion of the address. The IP address and the
mask are separated by a slash (/); for example, 2001:odb8::a2/
64.
host ipaddress: Matches packets with a destination IPv6
address and is an alternative to the IPADRESS/MASK variable
for addresses of specific end nodes. The HOST keyword
indicates that the address is of a specific end node and that no
mask is required.
time-range
Specifies the name of a time range that is created with the TIME-
RANGE command. You must create a time range before entering it
as a parameter value. See “TIME-RANGE” on page 1646.
vid
Indicates a VLAN identifier. Specify a VLAN if you want the ACL to
filter tagged packets. Omit a VLAN if you want the ACL to filter
untagged packets. Specify a value between 1 and 4094. You can
enter only one VID.
Mode
Configuration IPv6 ACL mode
Description
Use this command to create ACLs that identify traffic flows based on ICMP
type and source and destination IPv6 addresses.
Confirmation Commands
“SHOW ACCESS-LIST” on page 1641 and “SHOW INTERFACE
ACCESS-GROUP” on page 1643