Allied Telesis AT-8100 Series - Manual (Page 462)

Chapter 26: Link-flap Protection Commands
462
LINK-FLAP RATE
Syntax
link-flap rate <4 - 65535>
Parameters
rate
Specifies the number of link changes that constitute a link flap
event on a port. The range is 4 to 65535 changes. The default is 10
changes.
Mode
Global Configuration mode
Description
Use this command to specify the number of link changes that constitute a
link-flap event on a port. A link change is defined as any time a port loses
a link to an end node or establishes a link.
You may want to use this command in conjunction with “LINK-FLAP
DURATION” on page 460.
Confirmation Command
“SHOW LINK-FLAP” on page 464
Example
This example defines a link-flap event as eight link changes.
awplus> enable
awplus# configure terminal
awplus(config)# link-flap rate 8