Allied Telesis AT-8100 Series - Manual (Page 1261)

1261
Chapter 79
LLDP and LLDP-MED Commands
The Link Layer Discovery Protocol commands are summarized in
Table 128 and described in detail within the chapter.
Table 128. LLDP and LLDP-MED Commands
Command Mode Description
“CLEAR LLDP STATISTICS” on
page 1264 Privileged Exec Clears the LLDP statistics (packet and
event counters) on the ports.
“CLEAR LLDP TABLE” on page 1265 Privileged Exec Clears the LLDP information the
switch has received from its
neighbors.
“LLDP HOLDTIME-MULTIPLIER” on
page 1266 Global
Configuration Sets the holdtime multiplier value,
which the switch uses to calculate the
Time To Live (TTL) that it advertises
to the neighbors.
“LLDP LOCATION” on page 1267 Port Interface Adds LLDP-MED location information
to the ports on the switch.
“LLDP MANAGEMENT-ADDRESS”
on page 1269 Port Interface Replaces the default management IP
address TLV on the ports.
“LLDP MED-NOTIFICATIONS” on
page 1271 Port Interface Configures the switch to send LLDP-
MED topology change notifications
when devices are connected to, or
disconnected from, the specified
ports.
“LLDP MED-TLV-SELECT” on
page 1272 Port Interface Specifies the LLDP-MED TLVs the
ports are to transmit to their
neighbors.
“LLDP NON-STRICT-MED-TLV-
ORDER-CHECK” on page 1274 Global
Configuration Configures the switch to either accept
or discard LLDP-MED advertisements
if the TLVs are not in standard order.
“LLDP NOTIFICATIONS” on
page 1275 Port Interface Configures ports to send LLDP SNMP
notifications (traps).