Allied Telesis AT-8100 Series - Manual (Page 286)

Chapter 12: Power Over Ethernet Commands
286
POWER-INLINE USAGE-THRESHOLD
Syntax
power-inline usage-threshold threshold
Parameters
threshold
Specifies the power usage threshold in a percentage of the
switch’s total available system and PoE power. The range is 1 to
99%.
Mode
Global Configuration mode
Description
Use this command to set a threshold of the switch’s total available system
and PoE power. An SNMP trap is transmitted if the requirements of the
switch and the PDs exceed the threshold. To activate the trap, refer to
“SNMP-SERVER ENABLE TRAP POWER-INLINE” on page 297. The
default setting is 80%.
Confirmation Command
“SHOW POWER-INLINE” on page 288
Example
This example sets the threshold to 90% of the switch’s total available
power:
awplus> enable
awplus# configure terminal
awplus(config)# power-inline usage-threshold 90