Allied Telesis AT-8100 Series - Manual (Page 1033)

AT-8100 Switch Command Line User’s Guide
1033
 There is an LLDP-MED device connected to the port.
To set the priority value to be advertised for tagged frames, use the
SWITCHPORT VOICE VLAN PRIORITY command.
If the Voice VLAN details are to be assigned by RADIUS, then the
RADIUS server must be configured to send the attribute, Egress-VLANID
(56), in the RADIUS Accept message when authenticating a phone
attached to this port.
If the ports have been set to be edge ports by the SWITCHPORT VOICE
VLAN command, the NO form of this command will leave them unchanged
as edge ports. To set them back to their default non-edge port
configuration, use the NO SPANNING-TREE PORTFAST command (refer
to “NO SPANNING-TREE PORTFAST” on page 833).
The default setting for this feature is disabled.
Confirmation Command
“SHOW RUNNING-CONFIG” on page 170
“SHOW LLDP LOCAL-INFO INTERFACE” on page 1305
Examples
This example tells IP phones connected to port 1.0.5 to send voice data
tagged for VLAN 10:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.5
awplus(config-if)# switchport voice vlan 10
This example assigns the CoS value 5 to ports 1.0.2 and 1.0.3:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.2-port1.0.3
awplus(config-if)# switchport voice vlan priority 5
This example removes the CoS value from port 1.0.16 and returns to the
default CoS value, 5:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.16
awplus(config-if)# no switchport voice vlan priority
This example dynamically configures the VLAN ID advertised to IP phones
connected to port 1.0.1, based on the VLAN assigned by RADIUS
authentication (with the RADIUS attribute, Egress-VLANID, in the RADIUS