Allied Telesis AT-8100 Series - Manual (Page 1155)

1155
Chapter 74
SNMPv1 and SNMPv2c Commands
The SNMPv1 and SNMPv2c commands are summarized in Table 116 and
described in detail within the chapter.
Table 116. SNMPv1 and SNMPv2c Commands
Command Mode Description
“NO SNMP-SERVER” on page 1157 Global
Configuration Disables SNMPv1 and SNMPv2c on
the switch.
“NO SNMP-SERVER COMMUNITY”
on page 1158 Global
Configuration Deletes SNMPv1 and SNMPv2c
community strings.
“NO SNMP-SERVER ENABLE TRAP”
on page 1159 Global
Configuration Disables the transmission of all SNMP
traps, except for link status and
authentication traps, which are
disabled separately.
“NO SNMP-SERVER ENABLE TRAP
AUTH” on page 1160 Global
Configuration Disables the transmission of SNMP
authentication traps.
“NO SNMP-SERVER HOST” on
page 1161 Global
Configuration Removes the IP addresses of trap and
inform receivers from the community
strings.
“NO SNMP-SERVER VIEW” on
page 1163 Global
Configuration Deletes SNMP views.
“NO SNMP TRAP LINK-STATUS” on
page 1164 Port Interface Disables the transmission of SNMP
link status notifications when ports
establish links or lose links to network
devices.
“SHOW RUNNING-CONFIG SNMP”
on page 1165 Privileged Exec Displays the SNMPv1 and v2c
community strings and the IP
addresses of trap and inform
receivers.
“SHOW SNMP-SERVER” on
page 1166 Privileged Exec Displays the current status of SNMP
on the switch.
“SHOW SNMP-SERVER
COMMUNITY” on page 1167 Privileged Exec Displays the status of SNMPv1 and
SNMPv2c and the community strings.