Grass Valley Xstudio Vertigo Suite v.4.10 - Manual (Page 377)

15-24 Xstudio User Manual
Appendix C - Xstudio properties
InTransitionFeathering
[TransitionFeathering]
• Applies to: All primitives when the TransitionType property is set to
C OMPOSITE , and the InTransitionType is set to one of the following:
• R EVEAL
• S LIDE
• B OX
• Description: Determines the transparency gradient that is applied
to the leading edge of the object as it transitions.
• Accepted values: Assigning a positive value allows you to set this
property as a percentage of the image. For example, 0 results in a
zero percent or no gradient, while 1.0 is 100% transparent. Using
a negative value allows you to specify the value in pixels, rather
than a percentage of the object.
InTransitionHingePosition
[TransitionHingePosition]
• Applies to: All primitives when the TransitionType property is set to
C OMPOSITE , and the InTransitionType is set to one of the following:
• H INGE S WING I N
• H INGE S WING O UT
• H INGE S LIDE I N
• H INGE S LIDE O UT
• Description: Determines the position of the fixed hinge of the
object.
• Accepted values: Select from the drop-down list: L EFT , R IGHT ,
T OP , or B OTTOM .
InTransitionOffset
[TransitionOffset]
• Applies to: All primitives when the TransitionType property is set to
C OMPOSITE .
• Description: Determines the length of time (in seconds) that the “in
transition” will take to begin executing.
• Accepted values: Enter the NUMBER OF SECONDS that the in
transition will take to begin executing. -1 means start immediately
after the out transition completes. 0 value has them
simultaneously enter/exit.
Scene-side properties Descriptions