Grass Valley Xstudio Vertigo Suite v.4.10 - Manual (Page 35)

2-16 Xstudio User Manual
Getting started with Xstudio
Verifying Xstudio’s installation and setup
Once you have installed and setup Xstudio on a client workstation, it is recommended that
you perform the following quick procedure to verify that Xstudio was properly installed and
is working properly.
The following procedure is intended to test the proper functioning of Xstudio by loading a
template and scene into Xstudio (Design mode) and then previewing the playout on the
connected device using Xstudio’s Production mode.
1.
Open Xstudio.
2. Verify that Xstudio is actively connected to the Xmedia Server and the output device.
3. Open the Asset Browser and navigate to the T EMPLATES >D EMO _S AMPLES 08>M11
category.
4. Right-click on one of the templates listed within the M11 subcategory and select the
P
UBLISH T O >C ONNECTED D EVICE command.
5. Again in the Asset Browser’s M11 subcategory, double-click the template that you just
published.
The template and scene open in the project window.
6. Switch to Production mode by pressing C TRL +P or by double-clicking the D ESIGN LED
in the upper-right corner.
Xstudio switches over to Production mode and cues up the template in the Next To Air
window.
7. Click the T AKE button and the scene should playout on the active output device.
8. Click the C LEAR button and the scene should be removed from the active output device.
9. Return to Design mode by pressing C TRL +P or by double-clicking the D ESIGN LED in
the upper-right corner.
10. Close the project window by clicking the project window’s close button (X) or by
pressing C TRL +F4.
11. Click N O when prompted to save the template.