Grass Valley Xstudio Vertigo Suite v.4.10 - Manual (Page 295)

10-30 Xstudio User Manual
Adding logic to control objects
Load Scene
Adding this action to an event allows you to load a scene to the output device.
Set the following Action Parameters:
Log
Adding this action to an event allows you to log a message to the specified log file.
Set the following Action Parameters:
Name How you enter the scene name depends on how you created it.
•
If you built the scene in conjunction with a control screen, you must
enter the name given to the control side, not the scene side.
• If you built the scene independent of a control screen, enter the name
you saved the scene to.
In either case, enter the name in quotation marks.
Or,
•
Drag a scene (template/panel) from the Asset Browser or Gallery
Browser into the parameter’s field.
Location This is set automatically if you drag the scene (template/panel) into the
Name parameter. However, if you enter the name manually, then you can
use this row to specify the category (e.g. XMS:Templates).
Keyer Specifies the keyer layer on the device.
Output Determines where the scene will be loaded to.
•
P REVIEW : Displays on the preview display, not brought to air.
• O N A IR : Displays on the device.
• D EFAULT : Displays on the view where the action is being run from.
Log Enter either the location of the log file on the hard drive (e.g.
C:/Temp/Log.txt), or an expression to specify a log file.
Message Enter either specific text to be written to the log file, or an expression
(e.g. Control:SponsorImage).