Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 86)

76 Brocade Mobility Access Point System Reference Guide
53-1003100-01
5
1. Select the Configuration tab from the Web UI.
2. Select Devices.
3. Select System Profile from the options on left-hand side of the UI.
4. Expand the Interface menu and select Ethernet Ports.
FIGURE 12 Profile Interfaces - Ethernet Ports screen
5. Refer to the following to assess port status, mode and VLAN configuration:
Name Displays the physical port name reporting runtime data and statistics. Supported ports vary
depending on model.
Type Displays the physical port type.
Description Displays an administrator defined description for each listed port.
Admin Status A green check mark defines the port as active and currently enabled with the profile. A red “X”
defines the port as currently disabled and not available for use. The interface status can be
modified with the port configuration as required.