beautypg.com

Lan configuration – Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) User Manual

Page 32

background image

22

Brocade Mobility Access Point System Reference Guide

53-1003100-01

3

NOTE

When Bridge Mode is selected, WAN configuration cannot be performed and the Initial Setup Wizard
does not display the WAN configuration screen.

3. Select Next. The Typical Setup Wizard displays the LAN Configuration screen to set the access

point's LAN interface configuration. For more information, see LAN Configuration on page
3-22
.

LAN Configuration

Typical Setup Wizard

Use the LAN Configuration screen to set the access point's DHCP and LAN network address
configuration.

FIGURE 7

Initial Setup Wizard - LAN Configuration screen for Typical Setup Wizard

Set the following DHCP and Static IP Address/Subnet information: