Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 373)

Brocade Mobility Access Point System Reference Guide 363
53-1003100-01
5
6. Select + Add Row to define the following for critical resource configurations:
7. Select the Monitor Interval tab.
FIGURE 201 Device Overrides - Critical Resources screen - Monitor Interval tab
8. Set the duration between two successive pings from the access point to critical resource.
Define this value in seconds from 5 - 86,400. The default setting is 30 seconds.
IP Address Provide the IP address of the critical resource. This is the address used by the access point to ensure the
critical resource is available. Up to four addresses can be defined.
Mode Set the ping mode used when the availability of a critical resource is validated. Select from:
•
arp-only – Use the Address Resolution Protocol (ARP) for only pinging the critical resource. ARP is used to
resolve hardware addresses when only the network layer address is known.
•
arp-and-ping – Use both ARP and Internet Control Message Protocol (ICMP) for pinging the critical
resource and sending control messages (device not reachable, requested service not available, etc.).
Port Provide the port on which the critical resource is available. Use the spinner control to set the port number.
VLAN Define the VLAN on which the critical resource is available using the spinner control.