Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 482)

472 Brocade Mobility Access Point System Reference Guide
53-1003100-01
6
19. Set the following Dynamic Sample Recovery parameters:
20. Select OK to update the Smart RF Neighbor Recovery settings. Select Reset to revert to the last
saved configuration.
21. Select the Interference Recovery tab.
FIGURE 36 SMART RF Recovery Configuration screen - Interference Recovery tab
Dynamic Sample Enabled Select this option to enable dynamic sampling. Dynamic sampling enables an administrator to
define how Smart RF adjustments are triggered by locking retry and threshold values. This setting is
disabled by default.
Dynamic Sample Retries Use the spinner control to set the number of retries (1 - 10) before a power change is allowed to
compensate for a potential coverage hole. The default setting is 3.
Dynamic Sample
Threshold Use the spinner control to set the number of sample reports (1 - 30) used before dynamic sampling
is invoked for a potential power change adjustment. The default setting is 5.