Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 307)

Brocade Mobility Access Point System Reference Guide 297
53-1003100-01
5
Refer to the following manual session configurations to determine whether one should be created
or modified:
Select Add to create a new manual session, Edit to modify an existing session configuration or
Delete to remove a selected manual session.
FIGURE 153 Device Overrides - Network - L2TPv3 screen, Add T2TP Peer Configuration
IP Address Lists the IP address assigned as the local tunnel end point address, not the interface IP address.
This IP is used as the tunnel source IP address. If this parameter is not specified, the source IP
address is chosen automatically based on the tunnel peer IP address. This parameter is applicable
when establishing the session and responding to incoming requests.
Local Session ID Displays the numeric identifier assigned to each listed tunnel session. This is the pseudowire ID for
the session. This pseudowire ID is sent in a session establishment message to the L2TP peer.
MTU Displays each sessions’s maximum transmission unit (MTU). The MTU is the size (in bytes) of the
largest protocol data unit the layer can pass between tunnel peers in this session. A larger MTU
means processing fewer packets for the same amount of data.
Name Lists the name assigned to each listed manual session.
Remote Session ID Lists the remote session ID passed in the establishment of the tunnel session.