Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 125)

Brocade Mobility Access Point System Reference Guide 115
53-1003100-01
5
FIGURE 32 Network - L2TPv3 screen - General tab
5. Set the following General Settings for an L2TPv3 profile configuration:
6. Select the L2TPv3 Tunnel tab.
Host Name Define a 64 character maximum hostname to specify the name of the host that’s sent tunnel
messages. Tunnel establishment involves exchanging 3 message types (SCCRQ, SCCRP and SCCN)
with the peer. Tunnel IDs and capabilities are exchanged during the tunnel establishment with the
host.
Router ID Set either the numeric IP address or the integer used as an identifier for tunnel AVP messages. AVP
messages assist in the identification of a tunnelled peer.
UDP Listen Port Select this option to set the port used for listening to incoming traffic. Select a port from 1,024 -
65,353.
Tunnel Bridging Select this option to enable or disable bridge packets between two tunnel end points. This setting is
disabled by default.