Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 116)

106 Brocade Mobility Access Point System Reference Guide
53-1003100-01
5
3. Select System Profile from the options on left-hand side of the UI.
4. Expand the Interface menu and select WAN Backhaul.
FIGURE 28 Profile Interface - WAN Backhaul screen
5. Refer to the WAN (3G) Backhaul configuration to specify the access point’s WAN card interface
settings:
6. Define the following authentication parameters from within the Basic Settings field:
WAN Interface Name Displays the WAN Interface name for the WAN 3G Backhaul card.
Enable WAN (3G) Select this option to enable 3G WAN card support on the access point. A supported 3G card must
be connected for this feature to work.
Username Provide username for authentication support by the cellular data carrier.
Password Provide password for authentication support by the cellular data carrier.
Access Point Name (APN) Enter the name of the cellular data provider if necessary. This setting is needed in areas with
multiple cellular data providers using the same protocols such as Europe, the Middle East and Asia.
Authentication Type Use the drop-down menu to specify authentication type used by the cellular data provider.
Supported authentication options include None, PAP, CHAP, MSCHAP, and MSCHAP-v2.