Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 137)

Brocade Mobility Access Point System Reference Guide 127
53-1003100-01
5
FIGURE 40 Network - Spanning Tree screen
5. Set the following MSTP Configuration parameters:
MSTP Enable Select this option to enable MSTP for this profile. MSTP is disabled by default, so enable this
setting if requiring different (groups) of VLANs with the profile supported network segment.
Max Hop Count Define the maximum number of hops the BPDU considers valid in the spanning tree topology.
The available range is from 7 -127. The default setting is 20.
MST Config Name Define a 64 character maximum name for the MST region to use as an identifier for the
configuration.
MST Revision Level Set a numeric revision value ID for MST configuration information. Set a value from
0 - 255. The default setting is 0.