Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 469)

Brocade Mobility Access Point System Reference Guide 459
53-1003100-01
6
14. Set the following Video Access admission control settings for the radio QoS policy:
15. Set the following Low (Background) Access admission control settings for the radio QoS policy:
16. Select the Multimedia Optimization tab to configure advanced multimedia QoS configuration
and Smart Aggregation configuration for the radio’s QoS policy.
Enable Video Select this option to enable admission control for video traffic. Only video traffic admission control
is enabled, not any of the other access categories (each access category must be separately
enabled and configured). This feature is disabled by default.
Maximum Airtime Set the maximum airtime (in the form of a percentage of the radio’s bandwidth) allotted to
admission control for video supported client traffic. The available percentage range is from 0 -
150%, with 150% being available to account for over-subscription. This value helps ensure the
radio’s bandwidth is available for high bandwidth video traffic (if anticipated on the wireless
medium) or other access category traffic if video support is not prioritized. Video traffic requires
longer radio airtime to process, so set a longer airtime value if the radio QoS policy is intended to
support video. The default value is 75%.
Maximum Wireless
Clients Set the number of video supported wireless clients allowed to exist (and consume bandwidth)
within the radio’s QoS policy. Select from an available range of 0-256 clients. Consider setting this
value proportionally to the number of other QoS policies supporting the video access category, as
wireless clients supporting video use a greater proportion of resources than lower bandwidth traffic
(like low and best effort categories). The default value is 100.
Maximum Roamed
Wireless Clients Set the number of video supported wireless clients allowed to roam to a different access point
radio. Select from 0-256 clients. The default value is 10.
Reserved for Roam Set the roam utilization (in the form of a percentage of the radio’s bandwidth) allotted to admission
control for video supported clients who have roamed to a different managed radio. The available
percentage range is from 0 - 150%, with 150% accounting for over-subscription. The default value is
10%.
Enable Background Select this option to enable admission control for lower priority traffic. Only low traffic admission
control is enabled, not any of the other access categories (each access category must be separately
enabled and configured).
Maximum Airtime Set the maximum airtime (in the form of a percentage of the radio’s bandwidth) allotted to
admission control for low client traffic. The available percentage range is from
0 - 150%, with 150% being available to account for over-subscription. Best effort traffic only needs
a short radio airtime to process, so set an intermediate airtime value if the radio QoS policy is
reserved to support background data. The default value is 75%.
Maximum Wireless
Clients Set the number of low priority wireless clients allowed to exist (and consume bandwidth) within the
radio’s QoS policy. Select from 0 - 256 clients. The default value is 100.
Maximum Roamed
Wireless Clients Set the number of low priority supported wireless clients allowed to roam to a different access point
radio. Select from 0-256 clients. The default value is 10.
Reserved for Roam Set the roam utilization (in the form of a percentage of the radio’s bandwidth) allotted to admission
control for clients who have roamed to a different access point radio. The available percentage
range is from 0 - 150%, with 150% available to account for over-subscription. The default value is
10%.