Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 139)

Brocade Mobility Access Point System Reference Guide 129
53-1003100-01
5
To create static routes:
1. Select the Configuration tab from the Web UI.
2. Select Devices.
3. Select System Profile from the options on left-hand side of the UI.
4. Expand the Network menu and select Routing.
FIGURE 41 Network - Routing screen
5. Select IP Routing to enable static routes using IP addresses. This option is enabled by default.
Select the Policy Based Routing policy to apply to this profile. Select the Create icon to create a
policy based route or select the Edit icon to edit an existing policy after selecting it in the drop-down
list.
Select Add Row + as needed to include single rows with in the static IPv4 route table.