Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 374)

364 Brocade Mobility Access Point System Reference Guide
53-1003100-01
5
Configure the IP address for Port-Limited Monitoring in the Source IP for Port-Limited Monitoring
field. Sets the IP address used as the source address in ARP packets used to detect a critical
resource on a layer 2 interface. Generally, the source address 0.0.0.0 is used in the APR packets
used to detect critical resources. However, some devices do not support the above IP address and
drop the ARP packets. Use this field to provide an IP address specifically used for this purpose. The
IP address used for Port-Limited Monitoring must be different from the IP address configured on
the device.
9. Select OK to save the changes to the critical resource configuration and monitor interval.
Select Reset to revert to the last saved configuration.
Overriding a Services Configuration
Device Overrides
A profile can contain specific guest access (captive portal), DHCP server and RADIUS server
configurations. These access, IP assignment and user authorization resources can be defined
uniquely as profile requirements dictate.
To define or override a profile’s services configuration:
Select Devices from the Configuration tab.
Select Device Overrides from the Device menu to expand it into sub menu options.
Select a target device from the device browser in the lower, left-hand, side of the UI.
Select Services.
NOTE
A blue override icon (to the left of a parameter) defines the parameter as having an override applied.
To remove an override, go to the Basic Configuration screen’s Device Overrides field and select Clear
Overrides. This will remove all overrides from the device.