Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 45)

Brocade Mobility Access Point System Reference Guide 35
53-1003100-01
3
FIGURE 16 Initial Setup Wizard - WAN Configuration screen of the Advanced Setup Wizard
Set the following WAN parameters:
• Use DHCP - Select the radio control to enable an automatic network address configuration
using external DHCP servers. An automatic IP address is configured to the access point’s
WAN port using DHCP servers located on the WAN side of the network.
• Static IP Address/Subnet - Enter an IP Address and a subnet for the access point's WAN
interface. If Use DHCP is selected, this field is not available. When selecting this option,
define the following Default Gateway information as the field will become enabled on the
bottom portion of the screen. The IP address defined in this field is assigned to the WAN
interface. The Default Gateway is a router that serves as a access to other networks.
• Select the port that’s connected to the WAN – Select the port that is connected to the
WAN.
• Enable NAT on the WAN Interface – Select the option to enable Network Address
Translation on the selected GE interface.
Select Next. The Advanced Setup Wizard displays the Radio Configuration screen to set the access
point's radios. For more information, see Radio Configuration on page 3-36.