Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 349)

Brocade Mobility Access Point System Reference Guide 339
53-1003100-01
5
Click the Next button to go to the next configuration screen. Use the Back button to go to the
previous step.
FIGURE 181 VPN Step-By-Step Wizard - Step 3
Configure the following IPSec parameters:
Transform Set Transform set is a set of configurations exchanged for creating the VPN tunnel and impose a security
policy.The transform set is comprised of the following:
•
Encryption – The encryption to use for creating the tunnel.
•
Authentication – The authentication used to identify tunnel peers
•
Mode – The mode of the tunnel. This is how the tunnel will operate.
From the drop-down, select any pre-configured Transform Set or click the Create New Policy to create a
new transform set.