Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 195)

Brocade Mobility Access Point System Reference Guide 185
53-1003100-01
5
4. Expand the Security menu and select Bridge NAT.
FIGURE 83 Profile Security - Bridge NAT screen
5. Review the following Bridge NAT configurations to determine whether a new Bridge NAT
configuration requires creation or an existing configuration modified or removed:
6. Select Add to create a new Bridge VLAN configuration, Edit to modify an existing configuration
or Delete to remove a configuration.
ACL Lists the ACL applying IP address access/deny permission rules to the Bridge NAT configuration.
Interface Lists the communication medium (outgoing layer 3 interface) between source and destination points. This
is either the access point’s pppoe1 or wwan1 interface or the VLAN used as the redirection interface
between the source and destination.
NAT Pool Lists the names of existing NAT pools used with the Bridge NAT configuration. This displays only when
Overload Type is NAT Pool.
Overload IP Lists the address used globally and collectively for numerous local addresses.
Overload Type Lists the overload type used with the listed IP ACL rule. Set as either NAT Pool, One Global Address or
Interface IP Address.