Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 236
226
Brocade Mobility Access Point System Reference Guide
53-1003100-01
5
Select Device Overrides.
Select a target device MAC address from either the device browser in the lower, left-hand side of
the UI or within the Device Overrides screen.
The Basic Configuration screen displays by default.
FIGURE 111
Device Overrides - Basic Configuration screen
Set the following Configuration settings for the target device:
System Name
Provide the selected device a system name up to 64 characters in length. This is the device name
that appears within the RF Domain or Profile the access point supports and is identified by.
Latitude Coordinate
Optionally provide the latitude coordinate where the device is located. The valid value for this field
is in the range -90.0000 degrees to +90.0000 degrees. When provided, this enables the device to
be mapped on the geolocation map.
Longitude Coordinate
Optionally provide the longitude coordinate where the device is located. The valid value for this field
is in the range -180.0000 degrees to +180.0000 degrees. When provided, this enables the device
to be mapped on the geolocation map.
Area
Assign the access point an Area representative of the location the access point is physically
deployed. The name cannot exceed 64 characters. Assigning an area is helpful when grouping
access points in profiles, as access points in the same physical deployment location may need to
share specific configuration parameters in respect to radio transmission and interference
requirements specific to that location.
Floor
Assign the target access point a building Floor name representative of the location the access point
was physically deployed. The name cannot exceed 64 characters. Assigning a building floor name is
helpful when grouping devices in profiles, as devices on the same physical building floor may need
to share specific configuration parameters in respect to radio transmission and interference
requirements specific to that location.