Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 326)

316 Brocade Mobility Access Point System Reference Guide
53-1003100-01
5
NOTE
A blue override icon (to the left of a parameter) defines the parameter as having an override applied.
To remove an override, go to the Basic Configuration screen’s Device Overrides field and select Clear
Overrides. This will remove all overrides from the device.
FIGURE 165 Device Overrides - Network Forwarding Database screen
Define or override a Bridge Aging Time from 0, 10-1,000,000 seconds.
The aging time defines the length of time an entry will remain in the a bridge’s forwarding table
before being deleted due to lack of activity. If an entry replenishments a destination generating
continuous traffic, this timeout value will never be invoked. However, if the destination becomes
idle, the timeout value represents the length of time that must be exceeded before an entry is
deleted from the forwarding table. The default setting is 300 seconds.
Define or override the L3e Lite Entry Aging Time from 10 - 1,000,000 seconds.
Use the + Add Row button to create a new row within the MAC address table.
Set or override a destination MAC Address address. The bridge reads the packet’s destination MAC
address and decides to forward the packet or drop (filter) it. If it’s determined the destination MAC
is on a different network, it forwards the packet to the segment. If the destination MAC is on the
same network segment, the packet is dropped (filtered).
Define or override the target VLAN ID if the destination MAC is on a different network segment.
Provide an Interface Name used as the target destination interface for the target MAC address.
Select OK to save the changes and overrides. Select Reset to revert to the last saved configuration.