Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 135)

Brocade Mobility Access Point System Reference Guide 125
53-1003100-01
5
FIGURE 39 Network - Quality of Service (QoS) screen
5. Set the following parameters for IP DSCP mappings for untagged frames:
6. Use the spinner controls within the 802.1p Priority field for each DSCP row to change its
priority value.
7. Select the OK button located at the bottom right of the screen to save the changes. Select
Reset to revert to the last saved configuration.
Spanning Tree Configuration
Profile Network Configuration
DSCP Lists the DSCP value as a 6-bit parameter in the header of every IP packet used for packet
classification.
802.1p Priority Assign a 802.1p priority as a 3-bit IP precedence value in the Type of Service field of the IP header
used to set the priority. The valid values for this field are 0-7. Up to 64 entries are permitted. The
priority values are:
•
0 – Best Effort
•
1 – Background
•
2 – Spare
•
3 – Excellent Effort
•
4 – Controlled Load
•
5 – Video
•
6 – Voice
•
7 – Network Control