Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 275)

Brocade Mobility Access Point System Reference Guide 265
53-1003100-01
5
FIGURE 134 Device Overrides – Virtual Interfaces Dynamic Routing screen
Refer to the following to configure OSPF Settings.
Configure the OSPF Authentication Type settings by selecting from the drop-down list. The available
options are None, null, simple-password and message-digest.
Priority Select this option to enable or disable OSPF priority settings. Use the spinner to configure a value
from 0 - 255. This option sets the priority of this interface becoming the Designated Router (DR) for
the network. DRs provide routing updates to the network by maintaining a complete topology table of
the network and sends the updates to the other routers in the network using multicast. Setting a high
value increases the chance of this interface becoming a DR. Setting this value to Zero (0) prevents
this interface from being elected a DR.
Cost Select this option to enable or disable OSPF cost settings. Use the spinner to configure a cost value
from 1 - 65535. Use this option to set the OSPF cost of this interface. OSPF cost is the overhead
required to send a packet over this interface.
Bandwidth Select this option to enable or disable OSPF bandwidth settings. Use the spinner to configure a
bandwidth settings from 1 - 10,000,000 KBps. Use this option to set the bandwidth of this interface
in KBps.