Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 678)

668 Brocade Mobility Access Point System Reference Guide
53-1003100-01
12
• From a location on the device to another location on the same device.
2. Set the following file management source and target directions as well as the configuration
parameters of the required file transfer activity:
3. Select Ok to begin the file transfer. Selecting Cancel reverts the screen to its last saved
configuration.
To delete a file, select the file to be deleted and click Delete File button. The file is deleted
immediately.
Source Select Server to indicate the source of the file is a remote server.
Select Local to indicate the file is on the access point itself.
File If the source is Local, enter the name of the file to be transferred.
Protocol If Advanced is selected, choose the protocol for file management. Available options
include:
•
tftp
•
ftp
•
sftp
•
http
•
cf
•
usb1
•
usb2
•
usb3
•
usb4
This parameter is required only when Server is selected as the Source and
Advanced is selected.
Port If Advanced is selected, specify the port for transferring files. This option is not
available for cf, usb1, usb2, usb3 and usb4. Enter the port number directly or use
the spinner control.
This parameter is required only when Server is selected as the Source.
IP Address If Advanced is selected, specify the IP address of the server used to transfer files.
This option is not valid for cf, usb1, usb2, usb3 and usb4. If IP address of the server
is provided, a Hostname is not required.
This parameter is required only when Server is selected as the Source.
Hostname If needed, specify a hostname of the server transferring the file. This option is not
valid for cf, usb1, usb2, usb3 and usb4. If a hostname is provided, an IP Address is
not needed.
This field is only available when Server is selected in the From field.
Path/File If Advanced is selected, define the path to the file on the server. Enter the complete
relative path to the file.
This parameter is required only when Server is selected as the Source.
User Name If Advanced is selected, provide a user name to access a FTP or SFTP server.
This parameter is required only when Server is selected as the Source, and the
selected protocol is ftp or sftp.
Password If Advanced is selected, provide a password to access the FTP or SFTP server.
This parameter is required only when Server is selected as the Source, and the
selected protocol is ftp or sftp.
Target If Advanced is selected, set the target destination to transfer the file using FTP or
SFTP.
•
Select Server if the destination is a remote server, then provide a URL to the
location of the server resource or select Advanced and provide the same
network address information described above.
•
Select Access Point if the destination is an access point.