Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 473)

Brocade Mobility Access Point System Reference Guide 463
53-1003100-01
6
FIGURE 31 Association ACL screen
3. Select the + Add Row button to add an association ACL template.
4. If creating a new Association ACL, provide a name specific to its function. Avoid naming it after
a WLAN it may support. The name cannot exceed 32 characters.
5. Set the following parameters for the creation or modification of the Association ACL:
6. Select the + Add Row radio button to add MAC address ranges and allow/deny designations.
7. Select OK to update the Association ACL settings. Select Reset to revert to the last saved
configuration.
Association ACL Deployment Considerations
Association ACL
Before defining an Association ACL configuration and applying it to a WLAN, refer to the following
deployment guidelines to ensure the configuration is optimally effective:
Precedence The rules within a WLAN's ACL are applied to packets based on their precedence values. Every rule
has a unique sequential precedence value you define. You cannot add two rules’s with the same
precedence value. The default precedence is 1, so be careful to prioritize ACLs accordingly as they
are added.
Starting MAC Address Provide a starting client MAC address for non unicast and multicast packet transmissions.
Ending MAC Address Provide an ending MAC address for non unicast and multicast packet transmissions.
Allow/Deny Use the drop-down menu to either Allow or Deny access if a MAC address matches this rule.