Brocade Mobility Access Point System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 343)

Brocade Mobility Access Point System Reference Guide 333
53-1003100-01
5
Select Edit to modify the attributes of an existing policy or Delete to remove obsolete policies from
the list of those available. Select Add to create a new Network Service Alias.
FIGURE 176 Network - Alias - Network Service Alias Add screen
2. If adding a new Network Service Alias, provide it a name up to 32 characters.
NOTE
The Network Service Alias Name always starts with a dollar sign ($).
3. Within the Range field, use the + Add Row button to specify the Start IP address and End IP
address for the service alias range or double-click on an existing service alias range entry to
edit it.
4. Select OK when completed to update the network service alias rules. Select Reset to revert the
screen back to its last saved configuration.
Overriding a Security Configuration
Device Overrides
Protocol Specify the protocol for which the alias has to be created. Use the drop down to select the protocol from
eigrp, gre, icmp, igmp, ip, vrrp, igp, ospf, tcp and udp. Select other if the protocol is not listed. When a
protocol is selected, its protocol number is automatically selected.
Source Port
(Low and High) This field is only meaningful if the protocol is either tcp or udp.
Specify the source ports for this protocol entry. A range of ports can be specified. Select the Enter Range
button next to the field to enter a lower and higher port range value. Up to eight (8) such ranges can be
specified.
Destination Port
(Low and High) This field is only meaningful if the protocol is either tcp or udp.
Specify the destination ports for this protocol entry. A range of ports can be specified. Select the Enter
Range button next to the field to enter a lower and higher port range value. Up to eight (8) such ranges
can be specified.